
Whirlpool washers can display numeric codes and operating messages. This index distinguishes front-load and HE top-load models from the families documented in North America.
Front door, top lid and detergent dispensing
In Whirlpool’s North American support information, F5 E2 refers to a front-load door lock, while LdL and LdU describe lid conditions on HE top-load models. LOC or LC relates to the control lock: it does not mean that a lock is jammed.
The messages dET and F8 E2 affect the dispenser, but require different checks: detecting a cartridge is not the same as checking for residue in the system.
Choose the check based on when it happens in the cycle
- If filling takes too long, see F8 E1, LF and Lo FL and check which water inlets the model needs.
- If water remains in the washer, distinguish F9 E1 from drn according to the type of load.
- If suds extend the rinse cycle, Sud or Sd points to the detergent and dosage.
- An unbalanced load corresponds to Ofb; an excessive load, to OL.
Messages that may accompany normal operation
The official front-load table includes Int during cycle interruptions and rL/F34 when it detects laundry in the Clean Washer cycle. In the latter case, remove the laundry before running the maintenance cycle. PF on compatible top-load models indicates a power interruption. The steps for resuming depend on the control panel.
Keep the full model number, code and load type to hand before choosing a procedure. These correspondences are not a guide to every Whirlpool washer in Europe or to every appliance bearing the same logo.
Frequently Asked Questions
Where can I find the full model number of my Whirlpool washer?
Check the appliance’s identification plate and your purchase documents. Its location varies by design; look in the manual for the model and serial number section, and do not remove panels to find it.
Does the same code mean the same thing on all Whirlpool washers?
No. Whirlpool uses different platforms. This index is based on North American support information for front-load and HE top-load models; a model from another market needs its own manual.
How can I tell a normal message from a fault?
Read the entire message: LOC/LC indicates that the controls are locked, whereas F5 E2 relates to the front door lock. It also matters whether the appliance is following an expected routine or repeatedly interrupting the wash.
Does clearing the code confirm that the problem is fixed?
No. A reset may clear the display without correcting a water restriction, a door that does not close properly or a leak. Check the result of the permitted remedy, and do not repeat cycles if there are signs of risk.
What information should I give the service engineer?
Provide the model and serial numbers, the complete message, the load type and cycle stage, and whether water or laundry has been left inside. Mention any recent changes to the installation, detergent or load, and the checks you have carried out.
A straightforward adjustment may resolve an operating condition. If the same message returns despite correct installation and loading, keep a record and contact support.




