F8 E1, LF and Lo FL are associated with insufficient water entering the machine or filling taking too long on the documented front-loading and HE top-loading Whirlpool models. Check the manual for your model to confirm which code applies.
Check the water actually reaching the machine
The manufacturer’s documentation distinguishes between platforms, even when grouping these alerts together. On a machine with two inlets, a cold programme does not necessarily mean that the hot inlet does not also need to be supplied. Check that both taps are open if required by your installation.
- Check whether the household water supply is working and whether the problem started after a supply interruption, a move or a tap being turned off.
- Check any accessible hoses: a kink behind the machine can restrict the flow. Do not pull the machine by its connections.
- If the manual says you can clean the inlet screens, turn off the water and prepare the machine before disconnecting the hose. The guide to inlet screens explains this maintenance.
If water enters but the cycle does not progress
Note whether water drains away as it enters; the installation may be causing siphoning. Check the height and connection against the manual, without applying measurements from another washing machine. During protection, some platforms drain and stop responding temporarily: wait for the sequence specified before cancelling.
If the water supply is available and the alert reappears, request a diagnosis. The code alone does not identify a faulty inlet valve.
Recording whether filling never starts or starts and then stops can help distinguish between the two scenarios.
View all articles in Whirlpool washer error codes and messages
