HC warning on a Whirlpool washing machine: water connections reversed

HC indicates that the hot and cold water connections are reversed on the documented Whirlpool HE top-loaders. It applies only to machines that use both inlets.

Check the route of each hose

The manufacturer’s documentation says that HC appears at the end of the cycle. Before changing anything, identify the household hot-water outlet, the cold-water outlet and the markings on the washing machine inlets. Trace each hose from end to end; its colour alone does not confirm that it is connected correctly.

  1. Stop the machine and turn off both taps.
  2. If the manual authorises you to correct these connections and you can reach them without pulling the machine out, have a container ready for any residual water.
  3. Connect each water supply to its inlet as shown in the model diagram, keeping the approved seals and hoses in place.
  4. Turn the water supply back on and check the joints for leaks before carrying out the permitted test cycle.

If you cannot identify an outlet, or reaching it means moving a heavy or stacked appliance, ask the installer for help. The guide to a hot or cold water supply that is not working explains how to distinguish reversed connections from a lack of water supply.

HC after correcting the installation

Make a note of when it reappears and which connections have been checked. If the message persists, the machine needs diagnosing; do not keep swapping the hoses or apply this meaning to a single-inlet Whirlpool.

The check is complete when the connections are correct and watertight, not merely when HC disappears.

View all articles in Whirlpool washer error codes and messages