Whirlpool washers can display numeric codes and usage alerts. This index distinguishes front-load and HE top-load families documented in North America.
Front door, top lid, and dispensing
In Whirlpool's North American support, F5 E2 corresponds to the front-door lock, while LdL and LdU describe lid situations on HE top-loaders. LOC or LC belongs to the control lock: it does not mean a jammed latch.
The messages dET and F8 E2 affect the dispenser, but they require different checks: recognizing a cartridge is not the same as checking for residue in the system.
Choose the check based on the point in the cycle
- If it fills slowly, see F8 E1, LF, and Lo FL and review which water inlets the model needs.
- If it retains water, distinguish F9 E1 from drn according to the load type.
- When it extends rinses because of suds, Sud or Sd points to product and dosage.
- An unbalanced load corresponds to Ofb; too much laundry, to OL.
Messages that may accompany normal operation
The official front-load table includes Int during cycle interruptions and rL/F34 when it detects laundry in the clean washer program. In that last case, remove the laundry before servicing. PF, on compatible top-loaders, reports a power interruption. The steps to continue depend on the panel.
Keep the full model, code, and load type before choosing a procedure. These matches are not a table for all European Whirlpool units or for any appliance with the same logo.
Frequently Asked Questions
Where can I find my Whirlpool washer’s full model number?
Check the appliance rating plate and the purchase documentation. The location varies by design; look in the manual for the model and serial number section without removing panels to find it.
Does the same code mean the same thing on all of its washers?
No. Whirlpool uses different platforms. This index is based on North American support for front-load and HE top-load models; a model from another market needs its own manual.
How do I tell a normal alert from a fault?
Read the full message: LOC/LC indicates locked controls, while F5 E2 deals with the front lock. It also matters whether the appliance follows an expected routine or repeatedly interrupts washing.
Does clearing the code confirm the problem is solved?
No. A reset may remove the display without correcting a water restriction, a poor seal, or a leak. Check the result of the permitted correction and do not repeat cycles when there are signs of risk.
What information should I give the service technician?
Provide the model and serial number, the full message, load type, cycle phase, and whether water or laundry is left inside. Add any recent changes in installation, detergent, or load, and which check you performed.
An external fix may resolve a usage condition. If the same alert returns with proper installation and load, keep the record and contact support.