Sud or Sd warning on Whirlpool washing machines: too much foam

Sud or Sd indicates excessive suds on compatible Whirlpool washing machines. The washer may extend rinses and limit the spin cycle while it tries to remove them.

Allow time for the suds to clear

For front-loading machines, the manufacturer’s documentation describes pauses and extra rinses. If the machine continues with this routine and there are no leaks, don’t add detergent or repeatedly cancel the cycle to try to make it finish sooner. The duration depends on how much still needs rinsing out and on the programme.

Check the total dose

Check that the detergent is HE detergent if the manual requires it. Include any additives and products used to pre-treat clothes too: the amount in the dispenser isn’t always all that goes into the drum. A more concentrated product, softer water or a smaller load may call for a lower dose.

If you’ve changed detergent, compare the instructions on both packs; using the previous measure again may mean you use too much of the new detergent. The detergent quantity guide helps you adjust the dose for the load size and how soiled the clothes are.

Suds and restricted drainage

Check the drain hose: a kink or blockage may also trigger the warning. If the machine stops again or retains water after you’ve corrected the product and dose, contact support. Don’t pour in oil, extra fabric softener or homemade mixtures to make the bubbles disappear.

For the next wash, try the corrected dose; clearing Sud doesn’t indicate how much detergent is still in the clothes.

View all articles in Whirlpool washer error codes and messages