
Whirlpool washers may display numeric codes and use alerts. This index distinguishes front-load and HE top-load families documented in North America.
Front door, top lid and dispensing
In Whirlpool’s North American support information, F5 E2 refers to a front-door lock, while LdL and LdU describe lid conditions on HE top-load washers. LOC or LC relates to the control lock: it does not mean the door lock is stuck.
The messages dET and F8 E2 affect the dispenser, but require different checks: detecting a cartridge is not the same as checking for residue in the system.
Choose a check based on when it happens in the cycle
- If it takes a long time to fill, see F8 E1, LF and Lo FL and check which water inlets the model requires.
- If it retains water, distinguish F9 E1 from drn based on the load type.
- If it extends rinse cycles because of suds, Sud or Sd points to the product and dosage.
- An unbalanced load corresponds to Ofb; an excessive load, to OL.
Messages that may occur during normal operation
The official front-load chart includes Int during cycle interruptions and rL/F34 when it detects items in the Clean Washer cycle. In the latter case, remove the items before maintenance. On compatible top-load models, PF indicates a power interruption. The steps to resume depend on the control panel.
Keep the complete model number, code and load type on hand before choosing a procedure. These code mappings are not a chart for all European Whirlpool washers or every appliance with the same logo.
Frequently Asked Questions
Where can I find the complete model number of my Whirlpool washer?
Check the appliance identification plate and purchase documentation. Its location varies by design; look in the manual for the model and serial number section rather than removing panels to find it.
Does the same code mean the same thing on all Whirlpool washers?
No. Whirlpool uses different platforms. This index is based on North American support information for front-load and HE top-load washers; a model from another market needs its own manual.
How can I tell a normal alert from a fault?
Read the full message: LOC/LC indicates that the controls are locked, while F5 E2 concerns the front-door lock. It also matters whether the appliance is following an expected routine or repeatedly interrupting the wash.
Does clearing the code confirm that the problem is fixed?
No. A reset may clear the display without correcting a water restriction, an improperly closed door or a leak. Check the result of the permitted correction, and do not repeat cycles if there are signs of risk.
What information should I give the service technician?
Provide the model and serial numbers, the full message, load type, cycle stage, and whether water or clothing is retained. Mention any recent changes to the installation, detergent or load, and what checks you performed.
An external adjustment may resolve an operating condition. If the same alert returns with the washer properly installed and loaded, keep a record and contact support.




