Moving or transporting a washing machine and reinstalling it

Transporting a washing machine requires draining residual water and protecting the moving assembly in accordance with the manual. The transport position and approved transit locks depend on its design.

Plan the route and disconnection

Before disconnecting anything, measure doorways, turns and access points and arrange suitable handling equipment. A heavy appliance needs planned support and assistance; do not lift it by the door, detergent drawer, fittings or controls.

  1. Finish or cancel the cycle using the applicable recovery procedure.
  2. Isolate the power supply and turn off the water at safe points.
  3. Allow it to cool where necessary and carry out the authorised residual-water drain, with a container ready.
  4. Remove and secure the hoses and power cord as instructed.
  5. Fit the transit locks required for the model and protect any protruding parts.

Positioning and securing during transport

There is no general approval to lay a washing machine on its side. Permitted orientations, tie-down points and restrictions may differ for washer-dryer combinations or appliances with other internal systems. Follow the manual and tell the carrier what type of appliance it is.

Do not improvise bolts if the originals are missing, or tighten structural fasteners to immobilise the drum. If required, obtain compatible parts before moving the appliance.

Putting it back into service

At the new location, check the utilities, support and connection routes again. Remove any transit locks that need to come out, level the appliance and run the initial test. Do not apply a waiting time taken from another appliance; use the one specified for this design and transport.

A move is complete once reinstallation has been checked—not just when the machine has been placed in its new space.

View all articles in Installing a washing machine: requirements and checks