The first use should check the installation using the procedure for your model. There is no empty cycle, detergent dose or first-use temperature that suits every washing machine.
Before switching on
Check the model and documentation, ensure all packaging has been removed, transit bolts have been dealt with and the feet are stable. Check the water inlet, drain and power lead for anything that could trap or snag them. Make sure the connections are compatible before running a test: completing a cycle does not validate an unfamiliar electrical installation.
Follow the applicable procedure
The manual may specify an empty wash, cleaning off manufacturing residue or an installation test. Use only the product, programme and preparation specified. If the machine has an initial calibration, check when and in what order it should be done; the Samsung sequence applies only to compatible machines.
External checks during the test
- Water enters without any visible leaks at the connections.
- Water drains without overflowing or flowing back, and the hose stays in place.
- The machine runs steadily, without violent banging or moving around.
- There is no electrical smell, smoke or unusual heating at the connections.
- The cycle finishes, and any messages are consistent with the procedure.
Stay in a safe position and do not remove panels to observe the test. If a leak or dangerous behaviour occurs, stop using the machine and isolate the services from a safe point; do not repeat the test to see if the problem goes away.
If the test does not finish
Note the message, cycle stage and what you observed, then check with support or the installer about what still needs to be done. The installation must be resolved before you put in the first load of washing.
Record the test result and any adjustments made; this baseline makes it easier to interpret later changes.
View all articles in Commissioning and initial setup of a washing machine
