Transporting a washing machine requires removing residual water and securing the moving assembly as directed in the manual. The permitted transport position and locks depend on the machine’s design.
Plan the route and disconnection
Before disconnecting anything, measure doorways, turns and access points and arrange suitable handling equipment. A heavy appliance needs planned support and assistance; never lift it by the door, dispenser drawer, fittings or controls.
- Finish or cancel the cycle using the applicable recovery procedure.
- Safely disconnect the power supply and shut off the water.
- Let the appliance cool if necessary, then drain any residual water using the approved procedure, with a container ready to catch it.
- Remove and secure the hoses and power cord as directed.
- Install the transport locks required for the model and protect any protruding parts.
Positioning and securing during transport
There is no general rule that allows a washing machine to be laid on its side. The permitted orientation, tie-down points and restrictions may vary in combination units with other internal systems. Follow the manual and tell the carrier what type of appliance it is.
Don’t improvise with substitute bolts if the original ones are missing, or tighten structural fasteners to immobilize the drum. Get compatible parts before moving the appliance if they’re required.
Putting it back into service
At the new location, check the utilities, support and connection routing again. Remove any locks that must come off, level the appliance and run the initial test. Don’t apply a waiting period taken from another appliance; follow the instructions for this design and transport.
A move is complete once you’ve checked the reinstallation, not when the machine has been placed in its new spot.
View all articles in Washing machine installation: requirements and checks
