Moving or transporting a washing machine and reinstalling it

Transporting a washing machine requires draining residual water and securing the moving assembly in accordance with the manual. The transport position and permitted restraints depend on its design.

Plan the route and disconnect the machine

Before removing connections, measure doorways, turns and access points and arrange suitable handling equipment. A heavy appliance requires planned support and assistance; do not lift it by the door, drawer, fittings or controls.

  1. Complete or cancel the cycle using the relevant recovery procedure.
  2. Isolate the power supply and turn off the water at safe points.
  3. Allow the appliance to cool where appropriate and carry out the authorised residual-water drain, with a container ready.
  4. Remove and secure the hoses and power cable as instructed.
  5. Fit the transport locks required for the model and protect any protruding parts.

Positioning and securing during transport

There is no general permission to lay a washing machine on its side. The permitted orientation, tie-down points and restrictions may vary in combination units with other internal systems. Follow the manual and tell the transporter what type of appliance it is.

Do not improvise bolts if the original ones are missing, or tighten structural fixings to immobilise the drum. If compatible parts are required, obtain them before moving the appliance.

Putting it back into service

At the new location, check the supplies, support and route for the connections again. Remove any locks that need to come off, level the appliance and run the initial test. Do not apply a waiting time taken from another appliance; follow the time specified for that design and transport.

A move is complete only after the reinstallation has been checked, not when the machine has simply been placed in its new space.

View all articles in Washing machine installation: requirements and checks