Transporting a washing machine requires draining residual water and protecting the moving assembly in accordance with the manual. The transport position and permitted securing methods depend on its design.
Plan the route and disconnection
Before removing any connections, measure doorways, turns and access routes and arrange suitable handling equipment. A heavy appliance needs planned support and assistance; do not lift it by the door, detergent drawer, fittings or controls.
- Complete or cancel the cycle using the appropriate recovery procedure.
- Isolate the power supply and turn off the water at safe points.
- Allow the appliance to cool where necessary and carry out the authorised residual-water drain, with containment ready.
- Remove and secure the hoses and cable as instructed.
- Fit the transport bolts required for the model and protect any protruding parts.
Positioning and securing during transport
There is no general permission to lay a washing machine on its side. The permitted orientation, tie-down points and restrictions may differ in combination appliances with other internal systems. Follow the manual and tell the transport company what type of appliance it is.
Do not improvise bolts if the originals are missing or tighten structural fixings to immobilise the drum. Obtain compatible parts before moving the appliance if they are required.
Putting it back into service
At the new location, check the supplies, support and route of the connections again. Remove any transport bolts that need to come out, level the appliance and carry out the initial test. Do not apply a waiting time taken from another appliance; use the time specified for this design and transport.
A move is complete only after you have checked the reinstallation, not when you have put the machine in its new space.
View all articles in Washing machine installation: requirements and checks
