Levelling requires the intended supports to be in contact with the floor and the appliance to be positioned as specified in its manual. Adjusting the feet cannot compensate for an unsuitable floor or transport bolts that have not been removed.
Prepare for adjustment
Before moving or adjusting the appliance, isolate it according to the procedure and allow enough slack in the connections. Confirm that the transport bolts have been removed and that the floor is suitable. Do not put your hands under a tilted machine unless it is securely supported, and do not use the door or drawer to lift it.
Check and adjust
- Put the appliance in its intended position and check that it is not touching furniture or pipes.
- Check that the feet are in contact with the floor using the method in the manual; if the cabinet rocks, one of the feet may not be making proper contact.
- Check the level from side to side and from front to back on the specified surface.
- Adjust only the adjustable feet, using the specified limits and tools.
- Tighten the locknuts if fitted, then check the contact and level again, as tightening them may affect the adjustment.
Some designs have self-levelling rear feet; do not adjust them like manual screw feet without checking the procedure. Do not deliberately tilt the appliance to help it drain or improvise with wedges.
Check after installation
Check that the hoses have not kinked while positioning the appliance, and follow the specified test. Observe from outside; do not adjust the feet while any parts are moving.
If knocking or movement persists, stop any tests that cause violent movement and use the diagnostic procedure. Stability also depends on the suspension and load distribution.
Check that the feet are still in contact with the floor after securing them and after moving the appliance, before attributing vibration to the programme.
View all articles in Installing a washing machine: requirements and checks
