How to level a washing machine and secure its feet

Levelling requires the designated supports to be in contact with the floor and the appliance to be positioned as specified in its manual. Adjusting the feet will not compensate for an unsuitable floor or transit bolts that have not been removed.

Prepare for adjustment

Before moving or adjusting the appliance, isolate it according to the specified procedure and leave enough slack in the connections. Check that the transit bolts have been removed and that the floor is suitable. Do not put your hands underneath a tilted machine unless it is safely supported, and do not lift it by the door or drawer.

Check and adjust

  1. Place the appliance in its intended position and check that it is not touching any furniture or pipes.
  2. Check that the feet are in contact with the floor using the method in the manual; if the casing rocks, one of the feet may not be making contact.
  3. Check the level from side to side and from front to back on the specified surface.
  4. Adjust only the adjustable feet, within the specified limits and using the recommended tools.
  5. Tighten the locknuts if fitted, then recheck the contact with the floor and the level, as tightening them may affect the adjustment.

Some designs have self-levelling rear feet; do not adjust them like manual screw feet without consulting the relevant procedure. Do not deliberately tilt the appliance to help it drain, or improvise with wedges.

Check after installation

Check that the hoses have not been kinked while positioning the appliance, and follow the specified test. Observe from outside; do not adjust the feet while any parts are moving.

If knocking or movement continues, stop any tests that cause violent movement and use the diagnostic procedure. Stability also depends on the suspension and how the load is distributed.

Recheck that the feet are secure after adjustment and after moving the appliance, before attributing any vibration to the programme.

View all articles in Washing machine installation: requirements and checks