How to level a washing machine and secure its feet

For proper levelling, the intended supports must be in contact with the floor, and the appliance must be positioned as specified in its manual. Adjusting the feet cannot compensate for an unsuitable floor or shipping bolts that have not been removed.

Prepare for adjustment

Before moving or adjusting the appliance, disconnect it according to the prescribed procedure and leave enough slack in the connections. Confirm that the shipping bolts have been removed and that the floor is suitable. Never put your hands under a tilted machine unless it is securely supported, and do not lift it by the door or drawer.

Check and adjust

  1. Place the appliance in its intended position and check that it is not touching cabinets or pipes.
  2. Check the feet’s contact with the floor using the method in the manual; if the cabinet rocks, one of the feet may not be making contact.
  3. Check the level from side to side and front to back on the specified surface.
  4. Adjust only the adjustable feet, using the specified limits and tools.
  5. Tighten the locknuts, if present, and recheck the contact with the floor and the level, as tightening them may affect the adjustment.

Some designs have self-levelling rear feet; do not adjust them like manual screw feet without consulting the prescribed procedure. Do not deliberately tilt the appliance to help it drain or improvise with shims.

Check after installation

Check that the hoses have not kinked while positioning the appliance, and follow the specified test. Observe from the outside; do not adjust the feet while any parts are moving.

If banging or movement continues, stop any tests that cause violent movement and use the diagnostic procedure. Stability also depends on the suspension and load distribution.

Recheck that the feet are firmly seated after securing them and after moving the appliance, before attributing any vibration to the cycle.

View all articles in Washing machine installation: requirements and checks