Levelling requires the intended supports to be firmly in place and the appliance to be positioned as specified in its manual. Adjusting the feet cannot compensate for an unsuitable floor or transit bolts that have not been removed.
Prepare for adjustment
Before moving or adjusting the appliance, isolate it as instructed and leave enough slack in the connections. Confirm that the transit bolts have been removed and that the floor is suitable. Do not put your hands under a tilted machine unless it is securely supported, or use the door or drawer to lift it.
Check and adjust
- Place the appliance in its intended position and check that it is not touching furniture or pipes.
- Check that the feet are firmly in contact with the floor using the method in the manual; if the cabinet rocks, one of the feet may not be seated properly.
- Check the level from side to side and from front to back on the specified surface.
- Adjust only the adjustable feet, within the specified limits and using the recommended tools.
- Tighten the locknuts, if fitted, and recheck the contact and level, as tightening them may alter the adjustment.
Some designs have self-levelling rear feet; do not adjust these like manual screw feet without checking the instructions. Do not deliberately tilt the appliance to improve drainage or improvise with shims.
Check after installation
Check that the hoses have not become kinked when positioning the appliance, and follow the specified test. Observe from outside; do not adjust the feet while parts are moving.
If knocking or movement continues, stop any tests that cause violent movement and use the diagnostic procedure. Stability also depends on the suspension and load distribution.
Recheck that the feet are firmly in place after securing them and after moving the appliance, before attributing any vibration to the programme.
View all articles in Washing machine installation: requirements and checks
