The floor must support the appliance and limit flexing during operation. Adjusting the feet corrects how it sits; it does not prove that a timber floor or floor structure is sufficiently rigid.
Level and rigidity answer different questions
A level can be used to check the orientation of a surface or appliance. Rigidity describes how much the support deforms under load. A floor can be level yet flex during a spin cycle; it can also be rigid but still need the feet adjusted so they all make contact.
The suspension reduces some of the movement, but forces are still transmitted to the installation site. Noise heard in another room may depend on this structural transmission as well as the sound emitted into the air.
Material and actual structure
Concrete, a timber floor or an upper storey are not enough on their own to determine suitability. The actual thickness and construction, condition, supports and location all matter. If the manual specifies characteristics you cannot confirm, the installation needs to be assessed by the installer or a structural professional—not tested with violent spin cycles.
Bases, pads and wheels
A soft mat can affect stability and make it difficult for the appliance to sit evenly. A wheeled base must be approved and locked as intended. Pads cannot fix inadequate suspension or an unsuitable floor.
The pedestal adds height and forces on the fixings. Before installing accessories, check that the setup is compatible and that the appliance can still be accessed for servicing. Then carry out the relevant levelling.
If a machine that was previously stable starts moving, do not assume the floor is to blame: the change may be due to the load, fixings or components. The stated noise rating does not diagnose this behaviour either.
Check the support first, then how the appliance sits; adding a layer under the machine does not replace either check.
View all articles in Installing a washing machine: requirements and checks
