If no water is entering, start by checking the water supply and the conditions needed for filling. A load-detection delay or filling in intervals does not confirm a fault.
External checks, in order
- Confirm that the cycle received the start command and that the door was recognised. If the control panel is still waiting, check why the programme won’t start.
- Check whether water is available in the home and whether the taps supplying the washing machine are open. Don’t assume that a lack of water affects the whole house.
- Inspect the visible length of the hoses: a machine pushed against the wall can kink an inlet hose. Don’t pull on the connections or move a heavy machine without help.
- If there are two inlets, check both; the water mix and inlets used vary by cycle and model. If there is a leak-protection device, check what its status indicates and don’t bypass it.
When water is available but the flow is still insufficient
Sediment can build up in the inlet screens. Their approved cleaning requires turning off the water and isolating the appliance before disconnecting a hose. Don’t remove sealed parts or insert objects into a valve.
Check the installation documentation for the required pressure; water coming from another tap does not prove the washing machine is receiving the required flow and pressure.
If the external checks don’t explain the fault, the valve, wiring and control command need to be checked. Solenoid valve diagnosis should distinguish between these possibilities before a replacement part is chosen.
Tell the service technician whether no water enters at all or whether a steady trickle enters: this difference helps direct the circuit check.
View all articles in Problems with filling, water levels and drainage
