No hot or cold water entering a washing machine with two inlets

With a washing machine that has two inlets, an unexpected temperature may be due to the water supply, connections or programme mixing. Check each inlet before suspecting a valve.

Confirm which connection supplies each inlet

Check the appliance labels and manual: the colour of a hose alone does not prove which water it carries. After an installation or move, pay particular attention to whether the hot and cold connections have been swapped.

Note whether the same temperature always fails or whether it happens only with a particular programme. The machine may mix hot and cold water or need them at different stages, even when you select a cold wash. Do not turn off an inlet to experiment unless you have confirmed that the manufacturer allows the machine to operate that way.

What to check without accessing the inside

  • Whether water is available from each supply and its tap is open.
  • Whether a hose is kinked or crushed, especially behind the machine.
  • Any recent changes to the hot water system, plumbing or installation.
  • Whether the selected programme matches the temperature it actually controls; do not judge this by the clothes after a cold rinse.

If the connections need correcting, follow the requirements for hot and cold water inlets and avoid handling pressurised or hot lines. If water is not passing through an inlet despite a correct supply, the valve and control need to be assessed.

If the machine receives water but does not heat it internally, the troubleshooting path is different: see water not heating.

Record the result for each inlet and programme; “only the hot wash fails” is more useful than attributing the problem to a general temperature issue.

View all articles in Problems with filling, water levels and drainage