The washing machine won’t fill with water or fills very slowly

If no water is coming in, start by checking the water supply and the conditions that allow the machine to fill. A load-sensing delay or intermittent filling does not confirm a fault.

External checks, in order

  1. Confirm that the cycle received the start command and that the door was recognized. If the control panel is still waiting, check why the cycle won’t start.
  2. Check whether water is available in the home and whether the taps supplying the washing machine are open. Don’t assume that a lack of water affects the whole house.
  3. Inspect the visible sections of the hoses: a machine pushed against the wall can kink an inlet hose. Don’t pull on connections or move a heavy machine without help.
  4. If there are two inlets, check both; the water mix and inlets used vary by cycle and model. If there is a leak-protection device, check what its status indicates and don’t bypass it.

When there is a water supply but the flow is still insufficient

Inlet screens can collect sediment. Approved cleaning requires shutting off the water and disconnecting power to the machine before loosening a connection. Don’t remove sealed parts or insert objects into a valve.

Check the installation documentation for the required water pressure; water coming from another tap doesn’t prove that the washing machine is receiving the required flow rate and pressure.

If the external checks don’t explain the problem, the valve, wiring and control command need to be checked. Solenoid valve diagnosis should rule out those possibilities before a replacement part is selected.

Tell the service technician whether no water comes in at all or whether a steady trickle comes in: this distinction helps direct the circuit check.

View all articles in Problems with filling, water level and draining