The washing machine overfills or won’t stop taking in water

If the water level rises abnormally or threatens to overflow, stop using the machine and turn off the water supply from a safe location. The first priority is to stop the water coming in, not to restart the programme.

Contain the water without exposing yourself to wet connections

If you can reach them safely, turn off the water taps. Isolate the power from a dry location; don’t reach for a power point surrounded by water. Don’t force the door open or remove the filter cap while the drum is full.

Describe what you’ve already observed: whether the water level kept rising after you switched off the machine, whether foam appeared and which stage it started in. Don’t leave the water on to recreate a flood.

What each observation means

  • Water entering while the machine is idle: the valve not closing needs to be distinguished from external backflow. See water filling when the machine is off.
  • Water building up while the control is calling for water: the level-sensing circuit, as well as the water inlet control, may be involved.
  • Foam covering the glass: this doesn’t necessarily mean there’s an equivalent volume of water. The detergent and programme should be included in the record.

The normal water level depends on the machine’s design, programme and load. An additional planned fill does not necessarily indicate overfilling either; what’s concerning is a rise that cannot be controlled or exceeds the documented limits.

The technician should check both whether the solenoid valve closes properly and the system signals. Adjusting pressure-switch screws or blowing into electronic sensors can alter or damage components.

If you can’t stop the water supply or water reaches electrical installations, move away from the area and seek emergency assistance appropriate to the situation.

View all articles in Problems with filling, water levels and drainage