If no water is coming in, start by checking the water supply and the conditions needed for filling. A load-detection delay or filling in intervals does not confirm a fault.
External checks in order
- Confirm that the cycle received the start command and that the door was recognised. If the control panel is still waiting, check why the programme will not start.
- Check whether water is available in the house and whether the taps supplying the washing machine are open. Do not assume that a lack of water affects the whole house.
- Inspect the visible sections of the hoses: a machine pushed against the wall can kink an inlet hose. Do not pull on connections or move a heavy machine without help.
- If there are two water inlets, check both; the water mix and inlets used vary by cycle and model. If there is a leak-protection device, check what its status indicates and do not bypass it.
When the water supply is available but the flow is still insufficient
Inlet filters can collect sediment. Their approved cleaning requires turning off the water and isolating the machine before disconnecting a hose. Do not remove sealed parts or insert objects into a valve.
The required pressure is specified in the installation documentation; water coming from another tap does not prove that the washing machine is receiving the required flow and pressure.
If the external checks do not explain the fault, the valve, wiring and control command need to be checked. The solenoid valve diagnosis should distinguish between these possibilities before a replacement part is selected.
Tell the service team whether no water comes in at all or whether a thin, constant stream comes in: this difference helps them direct their checks of the circuit.
View all articles in Problems with filling, water level and drainage
