First use of a washing machine: installation test and initial cycle

The first use should check the installation by following the procedure for your model. There is no empty cycle, detergent dose or first-use temperature that applies to every washing machine.

Before switching on

Check the model and documentation, ensure all packaging has been removed, transit bolts have been dealt with and the supports are stable. Check the inlet, outlet and cable for any pinching. The connections must be compatible before you run a test: completing a cycle does not validate an unknown electrical installation.

Follow the applicable procedure

The manual may specify an empty wash, cleaning of manufacturing residue or an installation test. Use only the product, programme and preparation specified. If initial calibration is required, check that it is available and follow the correct sequence; the Samsung sequence applies only to compatible appliances.

External checks during the test

  • Water enters without any visible leaks at the joints.
  • Water drains without overflowing or flowing back, and the hose stays in place.
  • The machine runs steadily, without violent banging or moving.
  • There is no electrical smell, smoke or abnormal heating at the connections.
  • The test finishes and the messages match the procedure.

Stay in a safe position and do not remove panels to observe the test. If a leak or dangerous behaviour occurs, stop using the machine and isolate the supplies from safe points; do not repeat the test to see if the problem goes away.

If the test does not finish

Note the message, stage and observations, and check with support or the installer what still needs attention. The installation must be resolved before putting in the first load of laundry.

Record the test result and any adjustments made; this baseline makes it easier to interpret changes later.

View all articles in Starting up and setting up a washing machine