The floor must support the appliance and limit flexing during operation. Adjusting the feet corrects how it sits; it does not prove that a raised wooden floor or floor structure is sufficiently rigid.
Level and rigidity answer different questions
A level can be used to check the orientation of the surface or appliance. Rigidity describes how much the support deforms under load. A floor can be horizontal yet flex during the spin cycle; it can also be rigid but need the feet adjusted so that they all rest on the floor.
The suspension reduces some of the movement, but forces are still transmitted to the installation site. Noise heard in another room may depend on this structural transmission as well as on the sound emitted into the air.
The actual material and structure
Concrete, a raised wooden floor or an upper floor alone are not enough to establish suitability. The actual thickness and construction, condition, supports and location all matter. If the manual specifies requirements that you cannot confirm, the installation needs to be assessed by the installer or a structural professional—not tested with violent spin cycles.
Bases, pads and castors
A soft rug can affect stability and make it difficult for all the feet to rest evenly. A base with castors must be approved and locked as intended. Pads cannot make up for inadequate suspension or flooring.
The pedestal adds height and puts forces on the fixings. Before installing accessories, check that the assembly is compatible and that it allows access for servicing. Then carry out the appropriate levelling.
If a machine that was previously stable starts moving, do not assume the floor is at fault: the cause may be the load, fixings or components. Reading the declared noise level will not diagnose this behaviour either.
First check the support, then how the machine sits; adding a layer beneath the machine does not replace either check.
View all articles in Washing machine installation: requirements and checks
