Water appearing in the washing machine while it is switched off may be coming through the water supply or flowing back through the drain. Restarting it will not stop either of these physical sources of water.
Relate when the water appears to the water supply and drain
Turn off the washing machine’s water supply taps if you can do so safely, and prevent water from accumulating again. Note whether the problem appeared after using a sink, dishwasher or another appliance connected to the same drain. This timing may point to water flowing back from the drain.
A slow flow of water while the water supply is on may indicate a valve that is not sealing properly. If the water stops reappearing when you turn off the supply, this observation can help with diagnosis, but it does not mean you should dismantle the valve or replace a proper inspection of the pipework.
Do not rely on appearance alone
Clear water does not necessarily mean it is fresh water: water flowing back from the drain may be diluted. Cloudy water does not always identify the pipe either, as residue in the drum can make incoming water dirty. The timing, recurrence and connection with each water supply are more useful clues.
If a mechanical sealing fault is suspected, it requires a solenoid valve diagnosis. Disconnecting the electricity prevents the appliance from being activated, but it will not stop a valve that is mechanically allowing water through.
If there is water near electrical outlets, do not approach them to unplug the machine. Isolate the power from a dry location, and seek help if you cannot control the water flow.
Keep the water supply turned off until you find the cause; leaving the machine switched off does not guarantee that it will stay empty.
View all articles in Problems with filling, water level and drainage
