In a washing machine with two inlets, an unexpected temperature may be due to the water supply, connections or the programme’s mixing. Check each inlet before suspecting a valve.
Confirm which connection supplies each inlet
Check the appliance labels and manual: the colour of a hose alone does not prove which water it carries. After installation or a move, check in particular whether the hot and cold connections have been swapped.
See whether the same temperature is always affected or only one programme. The machine may mix hot and cold water or need them at different stages, even when you select a cold wash. Do not turn off an inlet to experiment unless you have confirmed that the manufacturer allows the machine to operate that way.
What to check without accessing the inside
- Water availability at each supply and whether its tap is open.
- Whether a hose is kinked or crushed, especially behind the machine.
- Recent changes to the domestic water heater, plumbing or installation.
- Whether the selected programme matches the temperature it actually controls; do not judge this by the clothes after a cold rinse.
If connections need correcting, follow the requirements for hot and cold water inlet and avoid handling pressurised or hot lines. If water does not flow through an inlet despite a correct supply, the valve and control need to be assessed.
If water reaches the machine but it does not heat it internally, the troubleshooting steps are different: see water not heating.
Note the result for each inlet and programme; “only the hot wash fails” is more useful than attributing the problem to a general temperature issue.
View all articles in Problems with filling, water level and drainage
