First use of a washing machine: installation test and initial cycle

The first use should check the installation using the procedure for the model. There is no empty cycle, detergent dose or first-use temperature that is suitable for every washing machine.

Before switching on

Check the model and documentation, packaging removed, transport bolts dealt with and stable feet. Check that the inlet, outlet and cable are not trapped. The connections must be compatible before carrying out a test: completing a cycle does not validate an unknown electrical installation.

Follow the relevant procedure

The manual may specify an empty wash, removal of manufacturing residue or an installation test. Use only the product, programme and preparation specified. If initial calibration is included, check that it is available and follow the required order; the Samsung sequence applies only to compatible appliances.

External checks during the test

  • Water enters without any visible leaks at the joints.
  • Water drains without overflowing, flowing back or moving the hose.
  • The machine runs steadily, without violent knocks or moving.
  • There is no electrical smell, smoke or abnormal heating of the connections.
  • The test finishes and the messages are consistent with the procedure.

Stay in a safe position and do not remove panels to observe the machine. If a leak or dangerous behaviour occurs, stop using it and isolate the supplies from safe locations; do not repeat the test to see if the problem disappears.

If the test does not finish

Keep a record of the message, cycle stage and observations, and check the outstanding issue with support or the installer. The installation must be sorted before putting in the first load of washing.

Record the test result and any adjustments made; this starting point makes it easier to interpret changes later.

View all articles in Commissioning and initial setup of a washing machine