The floor must support the appliance and limit flexing during operation. Adjusting the feet corrects how it sits; it does not prove that a suspended timber floor or floor structure is sufficiently rigid.
Level and rigidity answer different questions
A spirit level can be used to check the orientation of the surface or appliance. Rigidity describes how much the support deforms under load. A floor can be level yet flex during the spin cycle; it can also be rigid but need the feet adjusted so that they all make contact.
The suspension reduces some of the movement, but forces are still transmitted to the installation site. Noise heard in another room may depend on this structural transmission as well as on sound travelling through the air.
The actual material and structure
Concrete, a suspended timber floor or an upper floor are not, by themselves, enough to determine suitability. The actual thickness and construction, condition, supports and location all matter. If you cannot confirm the characteristics required by the manual, the installation needs to be assessed by the installer or a structural professional—not tested by running violent spin cycles.
Bases, pads and castors
A soft mat can affect stability and make it difficult for the appliance to sit evenly. A base with castors must be approved and locked as specified. Pads will not make up for inadequate suspension or flooring.
The pedestal adds height and forces on the fixings. Before installing accessories, check that the complete assembly is compatible and that it can be accessed for servicing. Then carry out the relevant levelling.
If a machine that was previously stable starts moving, do not assume the floor is to blame: the change may be due to the load, fixings or components. The declared noise rating does not diagnose this behaviour either.
Check the support first, then how the appliance sits; adding a layer beneath the machine is no substitute for either check.
View all articles in Washing machine installation: requirements and checks
