Error codes and alerts for ASKO washing machines

Error codes and alerts for ASKO washing machines

The ASKO alerts in this index are based on the W3096RW manual, type WM76S. Keep the decimal points and confirm that the codes correspond before applying them to another generation.

Choose the troubleshooting path based on the complete alert

The manual distinguishes E3 filling, E7 and E7.1 draining and E7.2 excess detergent. The decimal point helps distinguish incorrect dosing from a drainage restriction.

E13 concerns an unbalanced load. For the door, E2 and E22/E22.1 point to locking, while E23/E23.1 and E24 point to unlocking. A door that is physically closed does not prove that the locking mechanism has finished engaging.

E9/E9.1 indicates leak detection; E11 indicates an excessive water level. If water continues to enter while the alert is displayed, turn off the tap and request service.

Other codes in the WM76S table

CodeDocumented area
E0Incorrect settings.
E1 / E6Temperature or heating, respectively.
E10 / E10.1Water-level detection.
E12Motor or its control.
E26Door lock.
E36 / E37Communication or software compatibility between controls.
E40Prolonged power supply fluctuations.

The manufacturer's documentation describes the relevant reset or user check for each case and recommends contacting service if the issue persists; E37 requires assistance. This table does not recommend replacing components or entering a technical mode.

Remote connection

E48 affects the network and remote control on the WM76S. The manual says you can continue using other programmes on the appliance if there is no other fault; don't attribute a connection loss to a general washing malfunction.

Frequently Asked Questions

Where can I find the model and type of my ASKO washing machine?

On the documented W3096RW, the rating plate inside the door lists the model, type and serial number. For another generation, consult its manual to find the plate and copy all the details.

Why does a code change between ASKO generations?

Controls, features and detection systems vary between platforms. Do not apply the WM76S table to an earlier generation unless its manual explicitly confirms that it applies.

Should I write down the decimal point in the code?

Yes. On the WM76S, E7.1 warns of reduced drainage flow, while E7.2 concerns excess detergent. Omitting the decimal point could lead you to perform the wrong check.

Does a connection issue prevent washing from the control panel?

On the WM76S, E48 affects remote control and does not, by itself, prevent you from using other programmes on the appliance. Confirm the model and make sure there isn't a second washing-related alert before continuing.

Which alerts mean I should stop the washing machine?

A visible leak, water that keeps entering, an overflow or unusual electrical signs mean you should stop the machine. Persistent internal codes require service; don't repeat programmes to try to make them disappear.

The model and type must match the manual: the ASKO logo alone does not identify the generation.