
The ASKO warnings in this index are based on the W3096RW manual, type WM76S. Keep the decimal points and confirm the same code mapping before applying it to another generation.
Choose the relevant section based on the full warning
The manual distinguishes E3 filling, E7 and E7.1 draining and E7.2 excess detergent. The decimal point helps distinguish incorrect dosing from a drainage restriction.
E13 concerns an unbalanced load. For the door, E2 and E22/E22.1 point to locking, while E23/E23.1 and E24 concern unlocking. A door that is physically closed does not prove that the locking mechanism has finished engaging.
E9/E9.1 indicates leak detection; E11 indicates an excessive water level. If water continues to enter while the warning is displayed, turn off the tap and request assistance.
Other codes in the WM76S table
| Code | Documented area |
|---|---|
| E0 | Incorrect settings. |
| E1 / E6 | Temperature or heating, respectively. |
| E10 / E10.1 | Water-level detection. |
| E12 | Motor or its control. |
| E26 | Door lock. |
| E36 / E37 | Communication or software compatibility between controls. |
| E40 | Prolonged power supply fluctuations. |
The manufacturer's documentation describes the relevant reset or user check for each case and advises contacting service if the issue persists; E37 requires assistance. This table does not recommend replacing components or entering a service mode.
Remote connection
E48 affects the network and remote control on the WM76S. The manual says you can continue using other programmes on the machine if there is no other fault; do not mistake a lost connection for a general washing fault.
Frequently Asked Questions
Where can I find the model and type of my ASKO washing machine?
On the documented W3096RW, the rating plate inside the door shows the model, type and serial number. For another generation, check its manual to locate the plate and copy all the details.
Why does a code change between ASKO generations?
Controls, functions and detection systems differ between platforms. Do not apply the WM76S table to an earlier generation unless its manual explicitly confirms that it applies.
Should I note the decimal point in the code?
Yes. On the WM76S, E7.1 is a warning about a reduced drainage flow rate, while E7.2 concerns excess detergent. Omitting the decimal point could lead you to carry out the wrong check.
Does a connection problem prevent me from washing using the control panel?
On the WM76S, E48 affects remote control and does not, by itself, prevent you from using other programmes on the machine. Confirm the model and check that there is no second washing-related warning before continuing.
Which warnings mean I should stop the washing machine?
A visible leak, water that will not stop entering, an overflow or abnormal electrical signs mean you should stop the machine. Persistent internal codes require servicing; do not keep repeating programmes to try to clear them.
The model and type must match the manual: the ASKO logo alone does not identify the generation.




