
To interpret a Maytag alert, distinguish between front-load, HE top-load and control-panel functions. The references in this index are based on North American support information.
Two panel families
Front-load washer codes may include separate groups, such as F8 E1. HE top-load washers also display words or abbreviations such as drn, lid and Ofb. Copy all the characters before choosing a guide: don’t mistake a lid message for a door message.
In the official front-load table, LOC/LC identifies locked controls; dET depends on whether the dispenser uses a cartridge. These are different situations from a general start-up failure.
Water, suds and loads
If the appliance is slow to fill, see F8 E1, LF and Lo FL. If the problem occurs while draining, F9 E1 and drn separate the checks by platform. Don’t assume the pump needs replacing just because water remains.
Suds have their own troubleshooting path in Sud and Sd. For laundry, distinguish Ofb, an unbalanced load from OL, an overloaded washer. In both cases, the selected cycle matters, as well as how much the drum can physically hold.
Brief alerts and limited checks
Int may accompany a pause or cancellation; rL/F34 means removing laundry from the Clean Washer cycle on compatible front-load models. On top-load models, PF indicates a power failure, and lid means you should check the lid and cycle status. Follow the manual to continue: there is no reset that works for all these situations.
If there’s a leak, an electrical smell or a latch that isn’t working, stop using the washer. When requesting service, keep the model identification from the rating plate and note when the alert appeared.
Frequently Asked Questions
Where can I find the full model number of my Maytag washer?
The full number is on the rating plate and is usually included in the appliance documentation. Check the manual to find the plate on your model; the product line name is not a substitute for that reference.
Does the same code mean the same thing on all Maytag washers?
Not necessarily. Maytag front-load and HE top-load washers have different tables and controls; also confirm which market the appliance is intended for.
How can I tell a normal alert from a fault?
Check whether the message describes a selected function, such as Control Lock, or a condition that has prevented the cycle from finishing. A drain delay after cancelling follows a different troubleshooting path from a drain that repeatedly fails.
Does clearing the code confirm that the problem is fixed?
No. If the washer displays it again under the same conditions, the cause is still unresolved. A code disappearing after disconnecting power also doesn’t mean it’s safe to continue using the washer if there’s a leak or a faulty latch.
What information should I give the service technician?
Provide the model and serial numbers, the complete code, and whether it’s a front-load or top-load model. Note when it stops, what’s left inside, and whether you changed the load, product or connections just before the problem started.
If a code isn’t listed here, look it up in the exact model’s manual rather than automatically applying another brand’s interpretation.




