Collect accessible sand and mud before running another cycle. If particles also arrive with fresh water, check the water supply: cleaning the drum alone will not solve the problem.
Did they come in with the clothes or the water?
If they appear after a load with soil on it, start with the residue from that wash. If they return when there have been no dirty loads, or coincide with work on the water network, check the water at other taps and contact the supplier or the person responsible for the installation. Do not use a cleaning test to confirm whether water is potable.
Remove the particles without dragging them across the finish
- Leave the appliance empty, switched off and cool; isolate the power supply before working by hand.
- Collect visible deposits with a soft cloth, lifting them away in small amounts. Do not repeatedly rub dry sand over the metal or glass.
- Clean accessible edges and folds without pushing material through perforations or underneath the impeller.
- Check the maintenance instructions for the drain filter if it is accessible on your model. Deal with any retained water first.
- Only after removing the particles, run the approved empty cleaning cycle and check the result.
Do not tilt the machine to make the sediment come out, or dismantle the pump, drum or valve. A large accumulation that is out of reach may require professional servicing.
What to do if it happens again
If it seems to be coming from the inlet, check the water-supply mesh filters as described in the manual. Do not remove them permanently to prevent blockages. If the source was a load, cleaning the drum can complete the surface-level removal without turning it into a repair.
A new rubbing noise, failure to drain or residue that does not diminish are reasons to stop the test. Adding descaler or detergent will not, by itself, remove a quantity of trapped sand.
Identifying the source helps you avoid repeating a cleaning cycle that the next fill will undo.
View all articles in Cleaning the machine after accidental or heavy soiling
