After a tissue or an absorbent item has accidentally been left in the machine, first remove any paper, filling and gel you can reach. Do not add salt, solvents or mixtures to break them down: check the drainage and filters specified in the manual.
Identify what has dispersed
Remove the load when it is safe to open the machine, and separate out the visible waste. Paper fibres can stick to many surfaces; an absorbent item may release filling or gel. The aim is to collect the material, not push it towards the drain.
If water remains in the machine or it has not finished draining, do not open the filter directly. Retained water requires the model-specific procedure to be followed first. Do not force the door open to remove the load.
Recovering material from accessible areas
- With the machine stopped, cool and disconnected from the power supply for manual cleaning, collect by hand or with a soft cloth any material that comes away without forcing it.
- Check the drum and loading edge. On a front-loading machine, pay attention to the folds of the gasket without inserting tools into its holes.
- Check the pump filter and any other traps that the manual says can be maintained. Collect solid matter from outside the water circuit.
- Refit all parts and, only if drainage is working, complete the rinse or an approved maintenance cycle.
- Check that the inside is empty before putting in another load. If significant build-up continues to come out, arrange for an assessment.
If there is organic matter as well
Absorbent material and organic contamination are two separate issues. Removing gel does not confirm disinfection. If the incident requires it, check how to verify a disinfection method that is compatible with the appliance.
Do not repeat cycles in an attempt to dissolve a polymer, or use the clothes to collect what remains. If the machine does not drain, stop cleaning and report the incident to the service centre.
Treat the affected textiles separately; do not put them back in the drum while visible build-up remains in the machine.
Wait until all parts are fitted, drainage is normal and no accessible residue remains before putting in the next load.
View all articles in Cleaning the machine after accidental or heavy soiling
