Collect accessible sand and mud before running another cycle. If particles are also coming in with fresh water, check the water supply: cleaning the drum alone won’t solve the problem.
Did it come in with the laundry or the water?
If it appears after a load with soil, start by removing residue from that load. If it comes back with no dirty loads or coincides with work on the water system, check the water at other taps and contact your water provider or the person responsible for the plumbing. Don’t use a cleaning test to confirm that water is safe to drink.
Remove the particles without dragging them across the finish
- Leave the appliance empty, switched off and cool; disconnect the power before doing any manual work.
- Pick up visible deposits with a soft cloth, lifting them away in small amounts. Don’t repeatedly rub dry sand across the metal or glass.
- Clean reachable edges and folds without pushing material through openings or underneath the impeller.
- Refer to the drain filter maintenance instructions if it’s accessible on your model. First, deal with any water that has collected.
- Only after removing the particles, run an approved cleaning cycle with the machine empty and check the result.
Don’t tilt the machine to get sediment out or take apart the pump, tub or valve. A large amount of sediment that’s out of reach may require service.
What to do if it happens again
If it seems to be coming from the inlet, check the water supply screens as directed in the manual. Don’t remove them permanently to prevent clogging. If the source was a load, cleaning the drum can finish removing surface residue without turning it into a repair job.
Stop the test if you hear a new rubbing noise, the machine won’t drain, or the residue doesn’t decrease. Adding water softener or detergent won’t remove a trapped amount of sand on its own.
Identifying the source can prevent you from repeating a cleaning that the next fill will undo.
View all articles in Clean the machine after accidental or heavy soiling
