Remove accessible sand and mud before running another cycle. If particles are also coming in with fresh water, check the supply: cleaning the drum alone will not solve the problem.
Did it come in with the laundry or the water?
If it appears after a load of dirty laundry, start by removing the residue from that wash. If it returns after clean loads or coincides with work on the water network, check the water from other taps and contact your supplier or the person responsible for the installation. Do not use a cleaning test to confirm that water is safe to drink.
Remove the particles without dragging them across the finish
- Make sure the appliance is empty, switched off and cool; isolate the power supply before working by hand.
- Pick up visible deposits with a soft cloth, lifting them away a little at a time. Do not repeatedly rub dry sand against the metal or glass.
- Clean accessible edges and folds without pushing material through perforations or under the impeller.
- Refer to the maintenance instructions for the drain filter if it is accessible on your model. Deal with any trapped water first.
- Only after removing the particles, run the approved empty cleaning cycle and check the result.
Do not tilt the machine to make sediment come out, or dismantle the pump, drum or valve. A large build-up that is out of reach may require a service technician.
What to do if it happens again
If it seems to be coming from the inlet, check the water supply filters as described in the manual. Do not leave them out permanently to prevent blockages. If the source was a load of laundry, cleaning the drum can finish removing surface residue without turning it into a repair job.
A new rubbing noise, failure to drain or residue that does not diminish are reasons to stop the test. Adding water softener or detergent will not, by itself, remove a quantity of trapped sand.
Identifying the source avoids repeating a cleaning cycle that the next fill will undo.
View all articles in Cleaning the machine after accidental or heavy soiling
