E10, E11 or C1 on AEG machines, and a beep or flashing light on compatible models, indicate problems with the water circuit, usually water filling.
No water, slow water inlet or water loss during filling
The manufacturer's documentation groups issues related to the water supply and its flow through the machine. First, check the tap and whether water is available in your home. Check the accessible hose for any crushing or kinks.
If water enters but does not stay in the machine, compare the drain position with the PNC manual. A connection that allows siphoning cannot be fixed by increasing the detergent dose or restarting the machine.
Filters and foam, based on what you observe
Clean the inlet mesh filters only using the user procedure, first shutting off the water supply and preparing to disconnect them. Refit the seals and filters, and check for leaks. See maintaining inlet mesh filters.
If there is foam, check the detergent and quantity used: these can affect how the water circuit operates. Do not assume every E10 is caused by detergent, or open a pump filter without checking that it relates to the symptom and is covered in the manual.
If the warning returns despite a normal water supply and correct installation, contact a service technician with the PNC. Flow rates and heights should be checked in the relevant documentation; the code does not confirm a faulty solenoid valve.
Note whether water does not enter at all, or enters and then drains away; this difference helps guide the checks.
View all articles in AEG washing machine error codes and warnings
