E10, E11 or C1 on AEG machines, and a beep or flashing light on compatible models, indicate problems with the water circuit, usually filling.
No water, slow water intake or water loss during filling
The manufacturer’s documentation groups water supply and flow problems together. First, check the tap and whether your home has a water supply. Check the accessible hose for any kinks or bends.
If water enters but does not stay in the machine, compare the drain position with the PNC manual. A connection that allows siphoning cannot be fixed by increasing the dose or restarting the machine.
Filters and foam, depending on what you observe
Inlet mesh filters should only be cleaned using the user procedure, after turning off the water supply and preparing to disconnect them. Refit the seals and filters, then check for leaks. See cleaning inlet mesh filters.
If there is foam, check the product and quantity used: these can interfere with how the circuit operates. Don’t assume every E10 is caused by detergent, or open a pump filter without checking that this flow path matches the symptom and the manual.
If the warning returns with a normal water supply and correct installation, request service and provide the PNC. Flow rates and heights should be checked in the relevant documentation; the code does not confirm a faulty solenoid valve.
Note whether water never enters or enters and then drains away; this difference helps guide the inspection.
View all articles in AEG washing machine error codes and warnings
