Error E10, E11 or C1 on AEG washing machines: water supply

E10, E11 or C1 on AEG machines, and a beep or flashing light on compatible models, indicate problems with the water system, usually with filling.

No water, slow water intake or water loss during filling

The manufacturer’s documentation groups together problems with the water supply and flow. First, check the tap and whether your home has a water supply. Look at the accessible hose to see if it is crushed or kinked.

If water enters but does not stay in the machine, compare the drain position with the PNC manual. A connection that allows siphoning cannot be fixed by increasing the dose or restarting the machine.

Filters and foam, depending on what you observe

Inlet mesh filters should only be cleaned using the user procedure, after shutting off the water supply and preparing to disconnect the machine. Refit the seals and filters, then check for leaks. See maintaining inlet mesh filters.

If there is foam, check the detergent and amount used: these can affect how the water system behaves. Do not assume every E10 is caused by detergent, or open a pump filter without checking that this is relevant to the symptom and the manual.

If the warning returns with a normal water supply and correct installation, request a service visit and provide the PNC. Flow rates and heights should be taken from the relevant documentation; the code does not confirm a faulty solenoid valve.

Note whether water never enters, or whether it enters and then drains away; this difference helps guide the checks.

View all articles in AEG washing machine error codes and warnings