Error F8 E1, LF or Lo FL on Maytag washers: water inlet

F8 E1, LF and Lo FL indicate filling problems on compatible Maytag models. Check the water supply and installation before trying a reset.

Start with the water taps, not the control panel

The manufacturer’s documentation for Maytag groups low-flow or slow-fill alerts together. First check whether the water is shut off and whether the taps were closed after the washer was installed or moved. On machines with two water inlets, open both taps if the manual requires it, even if you’ve selected a cold wash.

Check the visible section of each hose. If one is kinked, adjust its path without straining the connections. Inlet screens should only be cleaned through the authorized access point, with the water shut off and the appliance prepared for the procedure; see how to check those screens.

Water flows in but doesn’t stay

If you hear the washer filling but it keeps waiting, note whether water is draining out at the same time. Compare the installation with the diagram for your model: a drain hose that’s positioned incorrectly can prevent the washer from retaining the required water level.

During a fill-protection cycle, the control may drain the washer and become temporarily unresponsive. Wait for this period to end and follow the control panel’s cancellation procedure. If the problem returns with the water supply and installation confirmed as correct, request service; repeatedly resetting the washer won’t tell you whether the cause is a restriction or an internal fault.

Note whether both inlets are affected or whether the problem depends on the selected water temperature.

View all articles in Maytag Washer Error Codes and Alerts