F7 E1 on the documented Maytag front-load washer indicates that the speed required for the cycle was not reached. The initial check depends on the installation and load.
What happened before the first alert
The manufacturer’s documentation recommends checking for an overloaded washer and shipping materials. If it was just installed, review the preparation section of the manual and remove any designated shipping restraints. Don’t identify bolts by appearance or remove cabinet parts to test the washer.
If the problem appeared with a large load, pause the cycle, wait for the door to unlock normally, and reduce the load according to the programme. Also check that an oversized item is suitable for that cycle; drum capacity isn’t the only limit.
Motor speed diagnostic information
Note whether the drum doesn’t move at all, turns at the beginning, or fails as the speed increases. These observations describe the behaviour; they don’t confirm that a Hall sensor, motor, or control board is faulty.
Only retry as permitted by the control panel after checking the accessible condition. If F7 E1 returns, request service. The motor speed detection guide explains the function involved without turning the code into an instruction to replace a part.
If there is intense banging, stop using the washer and report that symptom along with the code.
