Cleaning automatic dosing tanks and circuits

Cleaning an automatic dispenser removed from the washing machine and flushing its lines are different tasks. The manual should specify which container can be removed, which areas can get wet and whether a maintenance programme is available.

Before emptying the system

Identify the system name, its compartments and the product in each one. Check whether it needs cleaning when changing formulations, after being inactive for a while, or when a maintenance instruction appears. Don’t top up a dispenser with a mixture of products just to avoid emptying it.

For the range described by Whirlpool for its Load & Go dispenser, cleaning is recommended when changing the contents and before an extended period of non-use. These conditions apply to that system; they don’t authorise adding water to every automatic dispenser.

Removable dispenser: follow the documented access procedure

  1. Disable dosing and prepare the machine for removing the container as instructed in the manual.
  2. Collect any remaining product and dispose of it according to the label. Don’t mix it with waste from other cleaners.
  3. Only open covers and parts intended for the user. Keep water away from contacts, sensors and connectors.
  4. Clean and rinse only the permitted areas. If thickened detergent cannot be removed this way, don’t add solvents or use objects to probe the lines.
  5. Allow the surfaces to dry as required, then refit the container. Make sure it is seated correctly before refilling.

Internal tubes may need a different routine

A clean dispenser doesn’t prove that its suction lines are clean. If a programmed flush is available, use the approved medium and container. With Miele TwinDos, circuit maintenance is carried out using a dedicated function; a drum cycle is not a substitute.

When using the machine again, check that the contents match the compartment and review the automatic dosing settings. If it doesn’t draw product, leaks, or the warning remains after maintenance is complete, refer to the dosing fault checks without opening pumps or internal connections.

Before an extended absence, decide whether to empty or maintain the circuit using the available manual; don’t wait for the detergent to dry out.

View all articles in Which washing machine components to clean and how to identify them