Clean automatic dosing tanks and circuits

Cleaning an automatic dispenser tank outside the washing machine and flushing its lines are different tasks. The manual should specify which container can be removed, which areas can get wet, and whether there is a maintenance programme.

Before emptying the system

Identify the system name, its compartments and the product in each one. Check whether cleaning is required when changing the formulation, after a period of inactivity, or when a maintenance instruction appears. Do not top up a tank with a mixture of products just to avoid emptying it.

For the product range described by Whirlpool for its Load & Go dispenser, cleaning is specified when changing the contents and before an extended period of inactivity. These conditions apply to that system; they do not authorise you to put water into any automatic dispenser tank.

Removable tank: follow the documented access procedure

  1. Disable dosing and prepare the machine as instructed in the manual before removing the container.
  2. Collect any remaining product and dispose of it according to the label. Do not mix it with waste from other cleaners.
  3. Open only the covers and parts intended for the user. Keep water away from contacts, sensors and connectors.
  4. Clean and rinse only the permitted areas. If thickened detergent cannot be removed this way, do not add solvents or use objects to puncture the lines.
  5. Leave the surfaces to dry as specified, then refit the container. Check that it is properly seated before refilling.

The internal tubes may need a different routine

A clean tank does not prove that its suction lines are clean. If a scheduled purge is available, use the approved medium and container. On Miele TwinDos, circuit maintenance is carried out using a dedicated function; it cannot be replaced by a drum cycle.

When you use the appliance again, check that the contents match the compartment and review the automatic dosing settings. If the product is not being drawn in, there is a leak, or the warning remains after maintenance is complete, refer to the dosing fault checks without opening pumps or internal connections.

Before an extended period away, decide whether to empty or maintain the circuit by consulting the available manual; do not wait for the detergent to dry.

View all articles in Which Washing Machine Components to Clean and How to Identify Them