Automatic dosing needs to know which product it contains and how concentrated it is. Filling the reservoir without checking its settings can result in an incorrect dose, even if no warning appears.
Set it up with the product packaging handy
- Identify which reservoir is for detergent and which is for fabric softener or a second product, if your model allows it.
- Check which formulations and consistencies are approved. Do not put capsules, powder or liquids not intended for that format into the wrong circuit.
- Set the concentration or base dose using the exact method in the manual. A marketing description such as ‘concentrated’ does not always correspond to a numerical scale on the appliance.
- Enter the water hardness and soil-level settings when prompted, using accurate information.
- Check the dosing indicator before the first wash, then observe the result.
Switching to a manual dose
A special load, such as wool, may require a different detergent. If you use the manual compartment, deactivate the corresponding reservoir as instructed and confirm its status. Do not assume that adding product manually automatically cancels automatic dosing.
Changing products or resuming use
Check whether the reservoir and its circuit need to be emptied or cleaned before changing products. Mixing residues from different formulations or topping up over thickened detergent will not correct an incorrect calibration. Cleaning instructions are part of the system’s maintenance.
If residue is left on the clothes, first check the actual product, the selected concentration and whether an extra dose was added accidentally. Adjust settings only as instructed for the appliance; do not make up multipliers to correct the results.
Before a special load, check which reservoirs are still active. This helps prevent accidentally combining automatic and manual dosing.
View all articles in Laundry detergents, dosing and additives
