If the leak started after cleaning the filter, check that it is correctly positioned and sealed. First isolate the appliance and remove the water in a controlled way; do not open a plug while the drum is full.
Prepare for the inspection
Use the emergency draining procedure in the manual and wait until the water is no longer hot. The part to access is the drain pump filter, not an inlet mesh or lint filter.
What to inspect without forcing anything
- Debris on the seat that could prevent the seal from sitting properly.
- A cut, displaced or deformed seal.
- Cross-threading, an incomplete closure or a plug that does not reach its intended position.
- Cracks or visible damage to the plug or housing.
Electrolux advises checking the closure and making sure there is no leak in its guidance on filter leaks. The required force, final position and closing method depend on the model.
Do not use tools to force it past abnormal resistance. Do not add tape or silicone either: these could prevent it from seating correctly or make it harder to open next time.
When a part needs replacing
A damaged seal or plug must be identified using the parts diagram; a cracked housing may require the pump assembly to be inspected. If the leak continues after the authorised reassembly, stop using the appliance and arrange for assistance.
Routine cleaning and sealing are separate checks: a clean filter can still leak if its seal or closure is not fitted correctly.
View all articles in Water leaks from the washing machine: find the source
