If the leak started after cleaning the filter, check that it is properly positioned and sealed. First isolate the appliance and drain the water in a controlled way; do not open a plug while the tub is full.
Prepare for the inspection
Use the emergency drain procedure in the manual and wait until the water is no longer hot. The part to access is the drain pump filter, not an inlet screen or a lint filter.
What to inspect without forcing anything
- Debris on the seating surface that prevents the gasket from sitting flush.
- A cut, displaced or deformed gasket.
- Cross-threading, an incomplete closure or a plug that does not reach its intended position.
- Cracks or visible damage to the plug and housing.
Electrolux advises checking that the filter is closed and that there are no leaks in its guidance on filter leaks. The force required, final position and closing method depend on the model.
Do not use tools to force it past unusual resistance. Do not add tape or silicone either: these could prevent it from seating properly or make it difficult to open next time.
When a part needs replacing
A damaged seal or plug should be identified using the parts diagram; a cracked housing may require inspection of the pump assembly. If the leak continues after restoring the approved installation, stop using the appliance and request service.
Routine cleaning and sealing are different checks: even a clean filter can still leak if its gasket or closure is not correctly seated.
View all articles in Washing machine water leaks: find the source
