Water is leaking from the drain filter or plug

If the leak started after cleaning the filter, check that it is correctly positioned and sealed. First isolate the appliance and drain the water in a controlled manner; do not open a plug while the tub is full.

Prepare for the inspection

Use the emergency drain procedure in the manual and wait until the water is no longer hot. The part to access is the drain pump filter, not an inlet mesh or lint filter.

What to inspect without forcing anything

  • Debris on the seating surface that prevents the seal from sitting flush.
  • A cut, displaced or deformed seal.
  • Cross-threading, incomplete closure or a plug that does not reach its intended position.
  • Cracks or visible damage to the plug and housing.

Electrolux advises checking that the filter is closed and that there is no leak in its guidance on filter leaks. The force required, final position and closing method depend on the model.

Do not use tools to overcome unusual resistance. Do not add tape or silicone either: these could prevent the filter from seating correctly or make it difficult to open next time.

When a part needs replacing

A damaged seal or plug should be identified using the parts diagram; a cracked housing may require the pump assembly to be checked. If the leak continues after restoring the approved assembly, stop using the appliance and request assistance.

Routine cleaning and sealing are separate checks: even a clean filter can leak if its seal or closure is not fitted correctly.

View all articles in Water leaks in the washing machine: find the source