If the leak started after you cleaned the filter, check that it is fitted correctly and sealed properly. First isolate the appliance and drain the water in a controlled way; do not open a plug while the drum is full.
Prepare for the inspection
Use the emergency drain procedure in the manual and wait until the water is no longer hot. The part to access is the drain pump filter, not an inlet mesh or a lint filter.
What to inspect without forcing anything
- Debris on the seat that could prevent the seal from sitting properly.
- A cut, displaced or deformed seal.
- Cross-threading, an incomplete closure or a plug that does not reach its intended position.
- Cracks or visible damage to the plug or housing.
Electrolux advises checking that the filter is closed and that there are no leaks in its guidance on filter leaks. The force required, final position and closing method depend on the model.
Do not use tools to overcome unusual resistance. Do not add tape or silicone either: these could prevent the filter from seating correctly or make it difficult to open next time.
When a part needs replacing
A damaged seal or plug should be identified using the parts diagram; a cracked housing may mean that the pump assembly needs to be inspected. If the leak continues after the authorised refitting procedure, stop using the appliance and request assistance.
Routine cleaning and sealing are separate checks: even a clean filter can leak if its seal or closure is not correct.
View all articles in Water leaks from the washing machine: find the source
