On a washer with two inlets, an unexpected temperature can be caused by the water supply, connections or cycle mixing. Check each inlet before suspecting a valve.
Confirm which connection supplies each inlet
Check the appliance labels and manual: a hose’s colour alone doesn’t prove what water it carries. After an installation or move, check especially whether the hot and cold connections were swapped.
Notice whether the same temperature always fails or only on one cycle. The washer may mix both water supplies or need them at different stages, even when you select a cold wash. Don’t turn off an inlet to experiment unless you’ve confirmed the manufacturer allows the washer to operate that way.
What to check without accessing the inside
- Whether water is available from each supply and its taps are open.
- A kinked or crushed hose, especially behind the washer.
- Recent changes to the water heater, plumbing or installation.
- Whether the selected cycle matches the temperature actually controlled by the washer; don’t judge it by the laundry after a cold rinse.
If connections need correcting, follow the requirements for hot and cold water inlets and avoid handling pressurized or hot lines. If water won’t flow through an inlet despite a proper supply, the valve and control need to be assessed.
If the washer receives water but doesn’t heat it internally, the troubleshooting process is different: see water not heating.
Keep track of the result for each inlet and cycle; “only the hot wash fails” is more useful than attributing the problem to a general temperature issue.
View all articles in Problems with filling, water level and draining
