No hot or cold water entering a dual-inlet washing machine

On a washing machine with two inlets, an unexpected temperature may be due to the water supply, connections or programme mixing. Check each inlet before suspecting a valve.

Confirm which connection supplies each inlet

Check the appliance labels and manual: the colour of a hose alone does not prove which water it carries. After installation or moving, check particularly whether the hot and cold connections have been swapped.

Check whether the same temperature is always affected or whether it happens only on one programme. The appliance may mix both water supplies or need them at different stages, even when you select a cold wash. Do not turn off an inlet to experiment without confirming that the manufacturer allows the machine to operate that way.

What to check without accessing the inside

  • Whether water is available from each supply and its tap is open.
  • Whether a hose is bent or crushed, especially behind the machine.
  • Recent changes to the domestic water heater, plumbing or installation.
  • Whether the selected programme matches the temperature it actually controls; do not judge this by the laundry after a cold rinse.

If the connections need correcting, follow the requirements for hot and cold water inlets and avoid handling pressurised or hot lines. If water does not flow through an inlet despite a correct supply, the valve and controls need to be assessed.

If the appliance receives water but does not heat it internally, follow a different troubleshooting route: see water not heating.

Record the result for each inlet and programme; “only the hot wash fails” is more useful than attributing the problem to a general temperature issue.

View all articles in Filling, water-level and drainage problems