Automatic dosing needs to know which product it contains and how concentrated it is. Filling the tank without checking its settings can result in an incorrect dose, even if no warning appears.
Set it up with the product packaging at hand
- Identify which tank is for detergent and which is for fabric softener or a second product, if your model allows it.
- Check which formulations and consistencies are authorised. Do not put capsules, powder or liquids not intended for that circuit into it.
- Set the concentration or base dose using the exact method in the manual. A product description such as ‘concentrated’ does not always correspond to a numerical scale on the appliance.
- Enter the water hardness and soiling settings when prompted, using actual data.
- Check the dosing indicator before the first wash, then check the result.
Switching to a manual dose
A special load, such as wool, may require a different detergent. If you use the manual compartment, deactivate the corresponding tank as instructed and confirm its status. Do not assume that adding product manually automatically cancels automatic dosing.
Changing products or resuming use
Check whether the tank and its circuit need to be emptied or cleaned before changing products. Mixing leftover formulations or topping up detergent that has thickened will not correct an incorrect calibration. Cleaning instructions are part of system maintenance.
If residue is left on the clothes, first check the product actually used, the selected concentration and whether an extra dose was added accidentally. Adjust settings only as instructed for the appliance; do not make up multipliers to correct the results.
Before a special load, check which tanks are still active. This prevents accidentally combining automatic and manual dosing.
View all articles in Detergents, dosing and laundry additives
