How to check and replace the drain pump

To confirm a pump fault, first rule out a blocked outlet and a fault in the pump assembly or its control. Hearing it run does not prove that it is draining the required flow.

What to check before replacement

This is part of diagnosing water not draining. A blocked filter, a kinked hose or an external issue can prevent draining even when the pump is intact.

The technical inspection must distinguish between a damaged impeller, a leak from the housing or seal, an electrical fault and a missing control signal. The resistance felt when moving an impeller can depend on its design; small notches do not prove that it is faulty.

Preparation and scope of replacement

  1. Use the exploded diagram to identify whether the motor or the complete assembly is to be replaced, with its compatible part number.
  2. Isolate the power and water supply, carry out a safe drain-down and prepare to collect any residual water.
  3. Access the pump using the procedure for that platform, keeping track of the position of hoses, fasteners and connections.
  4. Replace the specified seals and components, reinstall all guards and carry out the prescribed validation.

Electrical measurements require the correct specifications and instruments. Do not connect a loose pump directly to mains power or use a resistance value taken from another model.

What to validate afterwards

It must drain correctly and remain leak-free at the joints that were worked on. If the drip is coming from the filter cap, check that seal rather than assuming a new motor will fix the leak.

Replacing the pump without checking the drain path can leave the same blockage and result in equally poor draining.

View all articles in Diagnosing and repairing washing machine components